4 Channel 12V Remote Control RF Module Transceiver

4 Channel 12V Remote Control RF Module Transceiver

Remote control intelligent RF controller has four relays, which enable the equipment to be controlled to achieve the rotation of the motor or the on/off switching of the switch and various requirements.

The product features stable performance, small size and high reception sensitivity. Mainly used in electric door, window, lifting equipment, industrial control and security industry, etc. is used.

Technical specifications:

Input Voltage: DC12V

Working Frequency: 433MHz

Channel Numbers: 4CH

Coding Way: Smart Learning

Operating Temperature: -40°C ~ +80°C

Output Current: ≤ 10A

Receiver Sensitivity: ≥-105dBm

Factory Default: Self-locking

Card Size: 72.5x52.5x23mm

Box Size: 75x54x28mm

Working Modes

Mode Clearing: Press and hold the button on the card, release it when the red light flashes.

Momentary Mode: This is the mode that starts the engine when you press the button and stops it when you release the button.

Press and hold the button on the card. When the red light flashes and then flashes momentarily again, release the button. Press the button again, release it when the red light turns on and press the "A" button on the remote control.

Self-Locking Mode: This is the mode that starts the engine when you press the button and stops it when you press it again. Press and hold the button on the card. The red light will blink and then blink again momentarily once and then when it blinks twice, stop pressing the button. Press the button again, release it when the red light turns on and press the "A" button on the remote control.

Interlocked Mode: It is referred to as interlocking mode. When you press the A button, it starts the engine in the 1st channel. When you press the B button, it turns off the 1st engine and starts the 2nd engine. In other words, it closes the last worker and runs the channel you just started. Press and hold the button on the card. The red light will flash, then flash again momentarily 1 time, then flash 2 times momentarily, and then when it flashes 3 times, stop pressing the button. Press the button again, release it when the red light turns on and press the "A" button on the remote control.