Arduino Nano Atmega328 V3.0 + Cable

Arduino Nano Atmega328 V3.0 + Cable

Arduino Nano is a small motherboard based on ATmega328P.
It has approximately the same features as the Arduino Duemilanove, only there is no DC power jack.
Arduino IDE application is required for programming.
The Arduino Nano is powered via a Mini-B USB connection.
The power supply automatically selects the high voltage source.
Operating voltage is in the range of 5V - 12V.
However, the recommended operating voltage must be more than 7V.
9V batteries will be sufficient for operation.
In this clone version of the Arduino Nano board, the CH340 IC is used instead of the Standard FTDI or 16U2 chips.
Thus, the cost was reduced but there was no change in performance.

Features:
Micro-Controller: ATmega328P
Working Voltage: 5V
Input Voltage (recommended): 7-12V
Digital I/O Pins: 14 (6 to provide PWM output)
Analog Input Pins: 8
Flash Memory: 32 KB
Operating Frequency: 16MHz
Dimensions: 19x43mm

Documents:
Arduino IDE
USB Chip Driver

Dimensions:
Length: 44.8mm (1.76')
Width: 17.6mm (0.7')

Package Included:
Nano 3.0 board
1x15 male header
2x3 male header (ICSP header)
USB Cable
​