L298N Dual Motor Driver Board with Voltage Regulator (Red PCB)

L298N Dual Motor Driver Board with Voltage Regulator (Red PCB)

This motor driver card, prepared to drive motors up to 24V, has two channels and provides 2A current per channel.
L298N motor driver IC is used on the board.
It can be used in sumo, mini sumo, line follower robots and a wide variety of motor control applications.
Apart from DC motors, it also allows stepper motor control.
For more detailed information, you can review the sample document below.

Features:
It can control two separate motors independently of each other.
It can deliver 2A current per channel.
It has an internal regulator.
It has high temperature and short circuit protection.
There are LEDs that light up according to the direction of motor rotation.
There is an internal cooler on the card.
Current sense pins are external.
There are 4 screw holes on the 4 sides of the card that you can fix to the desired surface.

Pin Connections:
ENA: Left motor channel activation pin
IN1: Left motor 1st input
IN2: Left engine 2nd trip
IN3: Right motor 1st input
IN4: Right engine 2nd input
ENB: Right motor channel activation pin
MotorA: Left motor output
MotorB: Right motor output
VCC: Supply voltage input (4.8V-24V)
GND: Ground connection
5V: 5V output

The product also includes pins with jumpers attached. These pins can be used for optional uses and to activate different features.
CSA: A is the current output of the motor driver channel. By removing the jumper from here, the current drawn can be read as analog voltage.
CSB: B is the current output of the motor driver channel. By removing the jumper from here, the current drawn can be read as analog voltage.
V1: It is a jumper connected to the pull-up resistor that pulls the IN1 input directly to 5V. In this way, 5V will always come to the pin unless you pull it to ground.
V2: It is a jumper connected to the pull-up resistor that pulls the IN2 input directly to 5V. In this way, 5V will always come to the pin unless you pull it to ground.
V3: It is a jumper connected to the pull-up resistor that pulls the IN3 input directly to 5V. In this way, 5V will always come to the pin unless you pull it to ground.
V4: It is a jumper connected to the pull-up resistor that pulls the IN4 input directly to 5V. In this way, 5V will always come to the pin unless you pull it to ground.
5V-EN: Jumper that activates and deactivates the 7805 line. When plugged in, the 5V output of the card becomes active and 5V can be drawn from there. If it is removed, this line becomes passive.