Single Channel 5V Relay Module Single Relay Board 1 Channel Arduino Relay

Single Channel 5V Relay Module Single Relay Board 1 Channel Arduino Relay

It is a module with a relay on it.
There are two indicator LEDs.
There is a 5 volt signal input pin for you to control the relay on the board.
You can adjust the switch position of the relay with the signal you give from here.
Thus, it can pass both ac and dc current through it.
It draws a current of 20mA from the microcontroller during the trigger signal.
A relay is a simple on/off switch.
It works when the input voltage is 5 Volts and turns off when the input voltage is 0 Volts.
The relay is also an electromechanical component that provides isolation.
The connection between the low power side, where the control (development) cards and the shield are connected, and the high power side, where the relay module operates, is disconnected via the relay.
In this way, high voltage/current protection is provided.
The relay is triggered with logic 0 (0V).

Features:
It can switch current up to 10A at 30VDC or 220VAC voltage.
The contacts of the single relay control card can be controlled with 5V.
Its body structure is such that it can stand with chemical environments or high temperatures.
It provides comfortable working opportunity without cable clutter and the need for soldering.
There are 3 connection terminals on the product:
COM(Common end),
NC (Normally Closed),
NO (Normally Open).

These terminals are taken out so that they can be used in situations where a short circuit or open circuit is required in case of triggering.
It can be easily used with Arduino cards and other cards with PIC, ARM, MSP430 MCU.
It is frequently used in various hobby, industrial and robotic projects.
There are control LEDs for the relay. It shows the information about the conduction and cut-off status by turning on the LEDs on it.
With this product, you can use a single lamp, a single motor or applications that require high voltage and current.
It is an easy-to-use, practical product.

Coil driving current: 20mA,
Number of outputs: 1 channel,
Control voltage: 5V TTL level,
Maximum switching voltage: 250VAC 30VDC,
Switching capacity: 7A 28VDC, 10A 125VAC, 7A 240VAC; 3A 120VAC,3A 28VDC,
Contact Material: AgCdO,
Contact resistance: 100mohm,
Switching time: 10ms maximum,
Release time: 5ms maximum,
Maximum ON/OFF switching: 30 times per minute (electrically),
Working temperature: -25°C ~ 70°C,
Life expectancy: 100,000 times (electrically).

Package Included:
1 x Single Channel 5V Relay Module